Документы

European Committee for Electrotechnical Standardization

Blank Detail Specification: Fixed low power wirewound surface mount (SMD) resistors - Incorporates Amendment A1: 2016
 N EN 140402

Annotation

Introduction

Blank detail specification

A blank detail specification is a supplementary document to the sectional specification and contains requirements for style and layout and minimum content of detail specifications. Detail specifications not complying with these requirements should not be considered as being in accordance with European Standards nor should they be so described.

In the preparation of the detail specification the content of EN 60115-8:2012, 1.4 should be taken into account.

The detail specification should be written by using the preferred values given in EN 60115-8.

The detail specification should contain a table of contents prior the first page of the actual specification. For the use of SI units refer to EN ISO 80000-1, for the use of letter symbols to be used in electrical technology, refer to EN 60027-1.

This Blank Detail Specification uses two different kinds of notes:

– NOTE for notes which give additional information intended to assist the understanding or use of the resulting document and therefore should be copied as NOTE into the drafted Detail Specification.

– NOTE (ed) for editorial notes which are intended to aid and direct the specification writer and therefore should not be copied into the drafted Detail Specification.

Identification of the detail specification and the component

The first page of the detail specification should have the layout recommended on page 6. The numbers in square brackets correspond to the indications to be completed thereunder: