Документы

ASTM International

Standard Test Methods for Breaking Tenacity of Manufactured Textile Fibers in Loop or Knot Configurations
 N D3217/D3217M

Annotation

These test methods cover the measurement of the breaking tenacity of manufactured textile fibers taken from filament yarns, staple, or tow fiber, either crimped or uncrimped, and tested in either a double loop or as a strand formed into a single overhand knot.

Methods for measuring the breaking tenacity of conditioned and wet (immersed) fibers in loop and knot form are included.

Elongation in loop or knot tests has no known significance, and is usually not recorded.

The basic distinction between the procedures described in these test methods and those included in Test Methods D2101 is the configuration of the specimen, that is, either as a double loop or in the configuration of a single overhand knot.

The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Автоматический перевод: