Документы

ASTM International

Standard Test Method for Brittleness Temperature of Plastic Sheeting by Impact
 N D1790

Annotation

This test method covers the determination of that temperature at which plastic sheeting 1.00 mm (0.040 in.) or less in thickness exhibits a brittle failure under specified impact conditions.

The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

NOTE 1—This test method was developed jointly with the Society of the Plastics Industry, primarily for use with plasticized vinyl sheetings. Its applicability to other plastic sheetings must be verified by the user.

This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

NOTE 2—This test method and ISO 8570 address the same subject matter, but differ in technical content.

*A Summary of Changes section appears at the end of this standard

Автоматический перевод:

Метод стандартной пробы для температуры хрупкости пластмассового защитного покрытия влиянием

Этот метод испытаний покрывает определение той температуры в который пластмасса, покрывающая 1.00 мм (0.040 дюйма.) или меньше в толщине показывает хрупкое разрушение при указанных условиях влияния.