Документы

ASTM International

Standard Specification for Welded Copper and Copper-Alloy Heat Exchanger Tube
 N B543/B543M

Annotation

This specification established the requirements for welded tube of copper and various copper alloys up to 31 8 in., inclusive, in diameter, for use in surface condensers, evaporators, heat exchangers, and general engineering applications. The following coppers or copper alloys are involved:2

The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Warning—Mercury has been designated by EPA and many state agencies as a hazardous material that can cause central nervous system, kidney, and liver damage. Mercury, or its vapor, may be hazardous to health and corrosive to materials. Caution should be taken when handling mercury and mercurycontaining products. See the applicable product Material Safety Data Sheet (MSDS) for details and EPA's website (http://www.epa.gov/mercury/faq.htm) for additional information. Users should be aware that selling mercury or mercurycontaining products, or both, in your state may be prohibited by state law. (Mercury is a definite health hazard in use and disposal. (See 12.1.1.))

*A Summary of Changes section appears at the end of this standard.

2 New designation established in accordance with Practice E527. In the new UNS system, the designations for copper alloys are simply expansions of the present standard designations by a prefix "C" and a suffix "00."