Документы

ASTM International

Standard Practice for Calibrating U-tube Density Cells over Large Ranges of Temperature and Pressure
 N D7961

Annotation

This practice outlines procedures for the calibration of U-tube density cells. It is applicable to instruments capable of determining fluid density at temperatures in the range –10 °C to 200 °C and pressures from just greater than the saturation pressure to 140 MPa. The practice refers to density cells as they are utilized to make measurements of fluids primarily in the compressed-liquid state. Examples of substances for which the density can be determined with a calibrated U-tube density meter include: crude oils, gasoline and gasoline-oxygenate blends, diesel and jet fuels, hydraulic fluids, and lubricating oils.

This practice specifies a procedure for the determination of the expanded uncertainty of the density measurement.

This practice pertains to fluids with viscosities < 1 Pa·s (1000 centipoise) at ambient conditions.

The values listed in SI units are regarded as the standard, unless otherwise stated. The SI unit for mass density is kilograms per cubic metre (kg·m-3) and can be given as grams per cubic centimetre (g·cm-3).

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

*A Summary of Changes section appears at the end of this standard

Автоматический перевод:

Общепринятая практика для калибровки ячеек плотности U-трубы по большим спектрам температуры и давления