Документы

ASTM International

Standard Specification for Copper and Copper Alloy Forging Rod, Bar, and Shapes
 N B124/B124M REV A

Annotation

This specification establishes the requirements for copper and copper alloy rod, bar, and shapes intended for hot forging. The following coppers and copper alloys are involved:

NOTE 1—Additional information about forging practice and forgings produced from these alloys is given in Appendix X1 and in Specification B283/B283M

Units—The values stated in either SI units or inchpound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use

*A Summary of Changes section appears at the end of this standard

Автоматический перевод:

Стандартная спецификация для медного и медного стержня ковки сплава, бара и форм

Эта спецификация устанавливает требования для стержня медного и медного сплава, панели, и формирует предназначенный для горячой ковки. Следующая медь и медные сплавы включаются: